LT864B Medium Intensity Solar Aviation Obstruction Light
LT864B Medium intensity solar obstruction light for marking Towers (Telecom, GSM), Smokestacks (heat-engine plant, coking plant, chemical plant etc),Buildings, Port devise, Construction machinery, wind power generator etc for air traffic warning.
Specifications
| Description |
Parameter |
| International standard |
ICAO; FAA-L864;MH-T6012-1999 |
| Light source |
LED |
| Color |
Red |
| Power supply |
18V 12W silicon solar panel |
| - |
12V 12AH battery |
| Power consumption |
30W |
| Intensity |
2000±500cd |
| Vertical degree |
3° |
| Horizontal degree |
360° |
| Flashing rate |
20 times/min |
| Flash duration |
100ms |
| Power consumption |
100,000hours |
| On/Off level |
50-200 lux |
| IP Protection |
IP65 |
| Ambient temperature |
-40°C ~ +55°C |
| Humidity |
10% ~ 95% (no coagulation) |
| Weight |
11kg |
| Material |
Case:cold rolled sheet(powder paint), Base:Aluminum alloy |
| - |
Housing:PC, Reflector:ABS |
| Continuous working time in cloudy days |
7 days(Ambient temperature 25°C) |
Functions & Features
- Meets optics standard.
- Based on LED technology, extremely reliable and cost saving.
- Shock-proof and corrosion resistant.
- Built-in connect terminals, and will connect well inside before Ex-work.
- Combustibility rating:UL94-V0.
- Highlight LED, LED lifetime more than 100,000hrs.
Mounting dimension(unit: mm)
Install steps
1.Use the M8 wrench to loosen the case on the M8*20 socket cap screw, Angle adjust bracket can rotate freely:
Pic 1 as below:
2.Fixed solar panel:
a. Firstly, the 2 sets of M8 screw assembly(Screw, spring washers flat pad)Connect solar panel and case together; Pic 2 as below;
Noted:Ensure two fixed together, no need too tight.
b. Use 2 sets of M8 screws assembly(Screw, spring washers , flat pad)with M8 nut put solar panels and angle adjustment bracket together, pic 3 as below:
Noted:Install hole location according to solar panels and horizontal plane angle, each hole please see pic 4.
The angle of the panels with horizontal plane shall be equal to the latitude.
c. Firstly, open the cover of the case kit socket, then put solar panel on the plug ino the socket of the component, fix the plug, Please see pic 5;
Noted:Plug and socket have anchor point, need match to fit in;
Plug nut must tighten to the socket, to prevent the bad line contact.
d.Use M8 fixed all screws.
Noted:All screws, nuts no loose.
3.Check the whole lamp:
a. According to the require of the 2nd step after assemble the solar panel, open the box switch?Dial ON?, Observe the light flash, if flash, solar battery to plug and socket not fix(in daytime);on the other hand, for next step:
b.Covered in solar panel with an object, re-checking light flash, flashing means finished product assembly, can be install on tower, closed button switch(Dial OFF)
Noted:Solar panel need 100% cover, ensure no light irradiation on it(to be night).
c.After the whole product install to the tower,turn on switch(dial ON), light start working.
